Non Modified Cellulose Ether (HPMC)

Non-modified cellulose ether

STD HK series products are developed to improve the construction performance of cement-based or gypsum-based dry-mix mortar. They can be used for plastering, painting, tile adhesive and exterior wall insulation systems.
STD HK series products can provide mortar with good construction performance, stable air content and good water retention.
If there is an “S” mark, it means that it has been surface treated and has a certain slow dissolution performance.
If better construction performance and excellent anti-sagging performance are required, STD HK series products can be used with other additives.

Product details

S means soluble dissolve
**2 % solution; on dry basis;Brookfield RVT; 20℃;20 rpm

Storage

STD HK series products are not prone to failure. It is recommended to use this product on a first-in-first-out basis. This product should be stored in its original packaging in a dry, clean environment and away from heat sources. This product is a hydrophilic product. The packaging can prevent moisture from entering to a certain extent, but if the storage environment is not good, its own moisture content may also increase.

Product Safety Information

STD HK is harmless according to EU laws on dangerous goods and preparations. Dust formation and accumulation should be avoided. Scattered product should be swept up in a dry state. Contact with water may cause a risk of slipping. Please follow the attached safety information and safety procedures. Any attached overview cannot replace the detailed data and instructions on the MSDS. Detailed MSDS can be obtained from the Hercules Temple EHS Department.

Declaration: The products displayed on this website are intended exclusively for industrial applications or scientific research. They are not intended for medical, pharmaceutical, or food use. In accordance with applicable laws and regulations, purchasing organizations must hold valid qualifications and approvals.